Auto-Guide™ 3000 Basic: Wheel Angle Calibration

Wheel Angle Calibration (Advanced Mode only)

Wheel angle sensor (WAS) calibration is required:

  • When using the system for the first time
  • If the machine steering is no longer accurate

WheelAngleCalibration_FIG1

1. Select WheelAngleCalibration_WrenchIcon (1).

2. Select WheelAngleCalibration_DownArrowFileIcon (2).

3. Select WheelAngleCalibration_DownArrowFileIcon (3).

4. Select WheelAngleCalibration_WrenchRulerIcon (4).

5. Select the WAS calibration icon (5).

6. Follow the prompts on the terminal (6).

When the calibration is complete, the terminal will return to the calibration menu.

FacebookTwitterEmailShare